Table of Contents
Advertisement
Quick Links
INSTRUCTION MANUAL
MICROWAVE FLOW SWITCH
Safety Precautions・・・・・・・・・・・・・・１
1．Outline ・・・・・・・・・・・・・・・・・・・２
2．Specifications ・・・・・・・・・・・・・・・・２
3．Name of each part ・・・・・・・・・・・・・・３
4．Environment in erection location (Condition)・・・５
5．Example of installation ・・・・・・・・・・・・５
6．Wiring・・・・・・・・・・・・・・・・・・・・６
7．Adjustment ・・・・・・・・・・・・・・・・・７
8．Maintenance・・・・・・・・・・・・・・・・・７
※An operator should read carefully this instruction manual and conduct
correct handing.
1-8-18 Norimatsu-Higashi,Yahatanishi-ku,Kitakyushu 807-0837 Japan
Phone No.(8193)691-3731 Fax No.(8193)691-3735
http://www.matsushima-m-tech.com
E-mail sales@matsushima-m-tech.com
FOR
TYPE
MWFS-SW-02C
Contents
MMWFS-002E
Rev3:May.28,2014
Advertisement
Table of Contents
Related Manuals for Matsushima MWFS-SW-02C
Summary of Contents for Matsushima MWFS-SW-02C
- Page 1 MMWFS-002E Rev3:May.28,2014 INSTRUCTION MANUAL MICROWAVE FLOW SWITCH TYPE MWFS-SW-02C Contents Safety Precautions・・・・・・・・・・・・・・１ 1．Outline ・・・・・・・・・・・・・・・・・・・２ 2．Specifications ・・・・・・・・・・・・・・・・２ 3．Name of each part ・・・・・・・・・・・・・・３ 4．Environment in erection location (Condition)・・・５ 5．Example of installation ・・・・・・・・・・・・５ 6．Wiring・・・・・・・・・・・・・・・・・・・・６ 7．Adjustment ・・・・・・・・・・・・・・・・・７ 8．Maintenance・・・・・・・・・・・・・・・・・７ ※An operator should read carefully this instruction manual and conduct correct handing.
- Page 2 Cause for any peripheral equipment or device. d. Accident beyond control and force majeure (fire, earthquake, flood, riots, etc.). Lack of instructions to MATSUSHIMA for information or safety requirements that can be predicted only by customers’ side. This warranty conditions do not limit customers’ legal right.
- Page 3 Flow Switch, vapor, floating dust due to the strong penetration ability. Therefore the Flow Switch can detect the flow through the insulated pipe. ２．Specification 2- 1. Type MWFS-SW-02C 2- 2. Power supply AC 90〜230V 50/60Hz（Max. 5.5W） 2m（The operating distance shall change 2- 3.
- Page 4 ３．Name of each part Figure 1 Panel detailed chart COARSE Volume FINE Volume POWER Lamp （Green） FAULT Lamp （Red） FLOW Lamp （Yellow） OFF DELAY Volume ON DELAY Volume Terminal ※Volume increases by turning clockwise. (The lead drawing out mouth was seen forward) Figure 1 Panel Table 1.Name and substance Name...
- Page 5 POWER FLOW FAULT Power supply Flow detection Failure alert AC90〜230V 50/60Hz （No flow） （When it is normal） Figure 2. Terminal array FLOW S FAULT Side Figure 3. Function chart − − ...
- Page 6 ４．Environment in erection location (Condition) 4-1. Temperature -10℃ 〜 +55℃ （It is not possible to use it in the place with the fear of freezing.） 4-2. Humidity 90％ or less （Transmitting part and receiving part is non condensing） 4-3. Pressure -980kPa〜+980kPa（-10〜+10kgf/cm ）...
- Page 7 Installation that considers adhesion and piling up Please install it referring to Figure 6. Please install the cover board of teflon with a low permittivity or a material ceramic etc. when this installation is difficult and give to me as an installation that penetrates the micro wave.
- Page 8 Note: Please note that the specifications or appearance may be changed without notice due to modification of the Flow Switch. Note: Matsushima does not take responsibility for any changes or modifications of the Flow Switch made by the user or unauthorized personnel.
Need help?
Do you have a question about the MWFS-SW-02C and is the answer not in the manual?
Questions and answers