Table of Contents
Advertisement
3 Description of each part
No.
Name
1
POWER
2
INDICATOR
Secondary power
3
fuse（3A）
4
FLOW CHECK
COOLANT OUTLET
5
COOLANT INLET
6
7
MOTOR SHAFT
8
COOLANT SUPLLY
COOLANT LEVEL
9
10
Setscrew (2 pcs.)
11
Adjustable anchor
12
Flow switch socket
13
AC380V
Air vent for cooling
14
15
Ground
Power switch. (○: OFF, I: ON)
Power lamp
Secondary power fuse.
[CAUTION] Before inspection, replacement work of the fuse(s), make
sure to turn off the power switch to prevent electric shock.
An observation window to observe the water flow from the "WATER
INLET".
[CAUTION] This indicator does not measure flow.
A capped outlet to connect hose for supply coolant.[Screw size: 5/8-18
UNF]
[CAUTION] * Use the cap to prevent water leakage when the hose is
disconnected.
A capped inlet to connect hose for back-coolant. [Screw size: 5/8-18
UNF]
[CAUTION] * Use the cap to prevent water leakage when the hose is
disconnected.
An opening to be used to rotate the motor shaft manually using minus (-)
screwdriver.
* Do not inset the screwdriver while the unit is in operation.
A cooolant supply port.
[CAUTION] * Keep the lid on unless refilling coolant.
It indicates the minimum cooolant level. Make sure to keep the cooolant
Min.
beyond the level at any time (including during operation.)
Retaining type setscrews for front cover.
* The front cover needs to be open to attach or remove the tank or filter.
Casters to be used to transfer the unit on the floor.
* Replace them with fixing legs if it is necessary
Flow switch signal output port，This switch is closed during normal cycle,
otherwise it is off
Input power cord（1.5 mm 2 ，2m）
（Please connect the input power）
Air vent for cooling fan.
[CAUTION] * Do not place anything that can block proper ventilation.
fan
Ground terminal（M6 bolts）It must be grounded reliably.
Description
(It is lit when the power (1) is turned on.)
5
Advertisement
Table of Contents
