Start Using Your Smartlinq; Switching Your Smartlinq On; Switching It Off - O2health SmartLinQ Manual

Your SmartLinQ's ready to use, but you should charge it
fully before getting started.
To do this, you need to:
1. plug your charger into an electrical socket. Make sure
the socket is switched on
2. plug the other end into the Power socket on your
SmartLinQ. You should see the Power light flashing.
When your SmartLinQ's fully charged, the Power light will
stop flashing and become a constant light.
If your battery's running low, your SmartLinQ will beep to
let you know. You'll get:
• three beeps when you have 40% power left
• one long beep when there's 20% power left.
It'll also beep to warn you of a number of other different
things. This depends on what you've set up on the Help at
Hand website.
7
Start using
your SmartLinQ

Switching your SmartLinQ on

1. Press and hold the red On/off button for three seconds.
2. You'll see the Signal light come on. It'll flash quickly
until it's found the signal.
3. After that, the light will carry on flashing slowly.

Switching it off

Press and hold the red On/off button for three seconds
until all the lights go off.
8