General Description - ICA 237409 Manual

TECHNICAL DATA
Model: 237409. Voltage: 220–240 V ~ 50/60 Hz.
Power: 1400 W.
EN

GENERAL DESCRIPTION

➊ Lid for the water container/
filter holder
➋ Control panel (see below)
➌ Glass jug
➍ Heating plate
BUTTONS ON THE CONTROL PANEL AND
INDICATOR LIGHT:
– 'START/STOP' button (when this is
switched on, 'AUTO' is locked).
'AUTO' – program button (when 'AUTO' is on,
the 'START/STOP' button is locked).
'PROG' – Button for setting pre­programmed
time.
'AROMA' – Aroma control button.
'H' – Button for timer adjustment.
'MIN' – Button for adjusting the minutes.
The LED light is continually red; brewing is
under
way or the machine is keeping the coffee hot.
The LED light flashes green: program, timer
setting.
The LED light is continually green; the
program is set.
LCD DISPLAY:
28:88 Shows the time or program time
(24hour display).
'AUTO': Shows that the program has been
set.
'BREW': Shows that the coffee is brewing.
'AROMA': Shows that the aroma control is on.
BEFORE USE:
1. Remove all packaging material.
2. Clean any removable accessories, the
scoop, filter basket and glass jug with
26
➊
➋
➌
➍
a mild detergent and rinse with water.
Dry thoroughly.
3. Run the coffee maker with clean water
without any coffee powder. Repeat this
three times, using fresh water each time,
in order to clean the coffee maker.
USE:
1. Plug the appliance into an earthed socket.
It will emit a long beep. Never touch the
appliance or cord with wet or damp hands.
2. Open the lid for the water container.
3. Fill the water container with clean water
up to the level that matches the amount of
coffee you want to brew. Every line corre­
sponds to two cups.
4. Place a paper filter into the filter holder.
5. Use the scoop to add the coffee. The
amount will vary depending on your prefe­
rence and taste.
6. Close the lid of the water container.
7. Put the glass jug on the heating plate.
EN
GENERAL DESCRIPTION
8. Press the 'START/STOP' button. The indi­
cator light goes red and 'BREW' appears
on the LCD screen. If you want to use the
aroma function, press the 'AROMA' button
on the control panel.
9. When the coffee has finished brewing, the
appliance will keep the coffee hot. It emits
three short beeps.
10. When the coffee has finished brewing,
the heating plate automatically keeps the
coffee hot for 40 minutes. It then switches
off. If the coffee does not need to be kept
hot, press the 'START/STOP' button. The
function that keeps the coffee hot will
switch off.
SETTING A TIME:
1. Plug the appliance into an earthed
socket. It will emit a long beep. Never
touch the appliance or cord with wet or
damp hands.
2. Use the buttons on the bottom of the con­
trol panel to set the timer. The time will
appear when the setting is complete.
'H' – Button for timer adjustment.
'MIN' – Button for adjusting the minutes
SETTING PROGRAMMED BREWING:
1. Press the 'PROG' button on the control
panel. The indicator light flashes.
2. Use the buttons on the bottom of the
As we are constantly developing the function and design of our products, we reserve the right to
make changes to the product without prior warning.
In accordance with the WEEE directive, every member state must ensure that electrical and
electronic waste is collected, recovered, handled and recycled correctly. Private households in
the EU can take this kind of waste to special recycling stations free of charge.
Produced in China for ICA AB, 171 93 Solna, Sweden.
Customer contact: +46 (0)20­83 33 33 or www.ICA.se
TECHNICAL DATA
Model: 237409. Voltage: 220–240 V ~ 50/60 Hz.
Power: 1400 W.
control panel to set the programmed time.
'H' – Button for timer adjustment.
'MIN' – Button for adjusting the minutes.
3. When you have set the programmed
time, press the 'AUTO' button once on the
control panel. After a few seconds, the
indicator light stops flashing and appears
continually instead. The program is set.
STOP PROGRAMMED BREWING:
1. When you have set a programmed time,
'AUTO' appears on the control panel.
2. Press 'AUTO'. 'AUTO' no longer appears
on the control panel. The program has
been stopped.
CLEANING:
1. Always unplug the appliance. Never
touch the appliance or cord with wet
or damp hands.
2. Always let the appliance cool down
before cleaning it.
3. Clean the outside of the appliance with
a damp cloth. Never immerse the
appliance into any liquid.
4. Clean any removable accessories, the
scoop, filter basket and glass jug with
a mild detergent and rinse with water.
Dry thoroughly.
The surfaces of the appliance get very hot
when in use.
EN
27