Cary Audio Design C 306 Owner's Manual page 13

Installation
This section describes the unpacking and installation procedures for the C 306 Preamplifier.
MAKE NO ATTEMPT TO PUT THE C 306 PREAMPLIFIER IN SERVICE WITH
THE TOP COVER REMOVED. CONTACT WITH HIGH VOLTAGE INSIDE THE
All shipping containers have been specifically designed to protect their contents and special care
has been taken to prevent damage under normal shipping conditions. Mishandling should be
evident upon inspection of the shipping container. If the C 306 Preamplifier mechanism or other
damage is found after unpacking and visual inspection, take care not to destroy the evidence so
that the shipping agent may inspect the damage. If necessary, document the damage with
photographs and contact the shipping company immediately.
Carefully remove your C 306 Preamplifier from its packing carton and examine it closely for
signs of shipping damage. It is highly recommended to save all original packing cartons to
protect your C 306 from damage should you wish to store it or ship it for after-sales service.
Replacement cartons and packing are available at a nominal charge from Cary Audio Design, if
ever required.
In general, the location of your new C 306 is not critical. However, certain precautions must be
taken to ensure optimum performance. Avoid extremely hot locations such as near radiators or
other heating units. Avoid getting it wet or using it near water. Do not stack the C 306 on top of
a power amplifier. Allow 4-6 inches (10-15cm) above the unit for proper ventilation.
The C 306 Preamplifier is designed to operate from AC mains current. The design AC voltage is
either 100-120V /or 200-240Volts AC at 50-60 Hz.
Balanced Inputs 1-3 : Accepts right-channel and left-channel balanced signals from source
Single-ended Inputs 4-6 : Accepts right-channel and left –channel (single-ended) inputs from
Balanced Main Outputs :These are for connection to the XLR input jacks of an accompanying
Single-ended Outputs : There are for connection to the RAC input jacks of an accompanying
_____________________________________________
WARNING
C 306 PREAMPLIFIER CAN BE FATAL !!!!!
2.1
2.2
2.3 Power Requirement
2.4
Equipment with balanced outputs.
Line-levels source equipment such as tuners, CD player.
power amplifier or electronic crossovers.
power amplifier or electronic crossovers.
Unpacking
Placement
Connections