Initial Operation - Bosch BCS220 Original Instructions Manual

OBJ_BUCH-3173-002.book Page 2 Wednesday, June 28, 2017 10:52 AM
English–2
Technical Data
Battery Charger
Article number
Rated voltage
Frequency
Output voltage
Charging current (max.)
Charging time
– PowerPack 300 approx.
– PowerPack 400 approx.
– PowerPack 500 approx.
Operating temperature
Storage temperature
Weight, approx.
Degree of protection
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Power cord
Article number
Rated voltage–Cable
Rated voltage–Connectors/plug-in connectors
Rated current – Connectors/plug-in connectors
Material–Cable
Safety standard–Cable
Safety standard–Connectors/plug-in connectors
Length, approx.
Operation

Initial Operation

Connecting the charger to the mains (see figure A)
 Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Plug the charger plug 3 of the power cord into the charger
socket 2 of the charger.
Connect the mains cable (country-specific) to the mains
supply.
Charging the removed battery (see figure B)
Switch the battery pack off and remove it from the holder of
the eBike. For this, read and observe the operating instruc-
tions of the battery pack.
0 275 007 XCX | (28.6.17)
Standard Charger
(36–4/230)
0 275 007 907
V~ 207...264
Hz 47...63
V 36
A 4
h 2.5
h 3.5
h 4.5
°C –5 ...+40
°C –10 ...+50
kg 0.8
IP 40
V~
V~
A
m
 Place down the battery pack only on clean surfaces. In
particular, avoid soiling the charge socket and the con-
tacts, e.g. by means of sand or soil.
Insert the charger plug 5 of the battery charger into the socket
6 on the battery pack.
Charging the battery on the Bike (see figures C and D)
Switch the battery off. Clean the cover of the charge socket 7.
Prevent especially the charge socket and the contacts from
getting dirty, e.g. by sand or soil. Lift the cover of the charge
socket 7 and plug the charge connector 5 into the charge
socket 6.
 Charge the battery only in accordance with all safety
instructions. If this is not possible, remove the battery
from the holder and charge it in a more suitable location.
When doing so, read and observe the operating instruc-
tions of the battery.
Standard Charger Compact Charger
(36–4/100-230) (36–2/100-240)
0 275 007 923 0 275 007 915
90...264
47...63
36
4
2.5
3.5
4.5
–5 ...+40
–10 ...+50
0.8
IP 40
Australia
1 270 020 344 1 270 020 332
300
250
10/2.5
PVC
AS/NZS 3191
AS/NZS 3112
AS/NZS 3109
1.5
Bosch eBike Systems
90...264
47...63
36
2
5
6.5
7.5
–5 ...+40
–10 ...+50
0.6
IP 40
Japan
300
125
7
PVC
JIS C3304
JIS C8303
1.5