Table of Contents
Advertisement
6 Powering-up
6 Powering-up
The slit lamp can be supplied with electricity by a separate mains adaptor or via an
examination unit.
a) Original mains adaptor:
Diagram 6-1: mains connection - back
1. Plug the slit lamp into connection (3).
2. Plug the focussing light into connection (2) (optional).
3. Earth the slit lamp to connection (4).
4. Plug the mains adaptor (1) into the mains socket using the power cable.
5. Press the on/off switch (7).
The slit lamp is now ready for use. You can change the brightness of the lamp in the slit lamp
using the dimmer switch (5).
b) Electricity via an examination unit
Only an expert must install the slit lamp to an examination unit. In particular, please ensure
that the supply voltage and power meet the requirements (see chapter on Technical data).
Use the appropriate operating controls on your examination unit to power the slit lamp.
(1) Mains connection and fuse
(2) Focussing light connection
(3) Slit lamp connection
(4) Protective earth connection
(5) Dimmer switch
(6) Problem indicator
(7) Power switch
bon SL-72 / SL-75
Diagram 6-2: mains connection - front
13/21
Advertisement
Table of Contents
