Setting-Up, Assembly And Repair - bon SL-72 Instruction Manual

5 Setting-up, assembly and repair

5 Setting-up, assembly and repair
a) Screw the gearwheel plates onto the table base with two recessed-head screws each.
Ensure that the sides of the gear wheels face outwards!
b) Screw the Teflon non-slip surface to the table base with four recessed-head screws.
c) Remove a gearwheel from the guiding rod and push it through the base. Then screw the
gear wheel back in.
d) Place the base on the table in such a way that the joystick is situated over the non-slip
surface and the gearwheels sit on the gearwheel plate.
e) Place one protective cover to the side of the assembled gearwheel plate and then push
the base forward as far as it will go.
f) Check that the facing gearwheel is also on the last pinion. This is the only way of ensuring
that the two gear wheels run parallel.
g) Place the second protective cover on the gearwheel plate.
Drill-holes for
gearwheel plate
Drill-holes for the non-
slip surface
Diagram 5-1: Measurements for drill-holes
bon SL-72 / SL-75
11/21