Advertisement
How to use the dishwasher
1. After loading the dishwasher, turn on
the water supply tap and open the
dishwasher door.
2. Press the On button to switch the
dishwasher on. One of the
programme indicator lamps will
light up.
3. Press the programme selector button
until the corresponding indicator lamp
switches on. If required, select options
(if supplied).
4. Press the Start button to start the selected
wash programme. The corresponding
indicator lamp switches on. Once set,
the programmed data cannot be altered
by pressing the programme selector
button.
Note: Once the Start button has been
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, open the door
(Caution: danger of scalding
from steam!) and press the Start
button for about 5 seconds, until the
Start indicator lamp switches off.
Select a new programme using the
programme selector knob and
press the Start button.
Note: If the dishwasher is switched off
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door
if strictly necessary during a
wash cycle and exercise
maximum caution. Danger of
scalding from steam.
5. To indicate the end of a programme, an
acoustic signal is activated 4 times, the
Start indicator lamp switches off and
the End indicator lamp (if fitted)
lights up (for approx. 30 min).
6. Only open the door once the wash cycle
has terminated (caution: danger of
scalding from steam) and press the OFF
button to switch the dishwasher off. All
the indicator lamps switch off.
7. Unload the lower rack before the upper
one. Close the water tap.
Upper rack
Half load / Multizone:
If the upper rack only is to be loaded, place
the cutlery basket (B) in the upper rack.
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
Please read the user instructions carefully.
Upper and lower rack
•
To lower: pull out the two side
handles and gently lower the rack.
•
To raise: pull up the two side handles
until the rack clicks into place.
•
The rack must be level on both
sides.
Crockery Holders:
•
Down:
cups and long-stemmed glasses.
•
Up: plates.
Glass holder:
Lower rack
A
A
C
Half load / Multizone:
Loading the lower rack only gives
greater washing power, especially for
plates and saucepans.
Plate holders:
•
(A) may be lowered to increase
available space.
Cutlery basket:
The cutlery basket can be removed to
increase (B + C) available space.
•
It can be placed on the upper rack (B)
when the Half load/Multizone function
is selected.
C
B
Advertisement
