Table of Contents
Advertisement
4 INSTALLATION
The elite Panaboard is used by mounting it on a wall or a stand (sold separately).
When mounting the elite Panaboard on a wall, refer to the following steps.
When using a stand (sold separately), refer to the following steps and the Installation Manual
for Model No.UB-T580/T580W.
4.1.
Installation Requirements
(1) The elite Panaboard is for indoor use. It cannot be used outdoors. Neither can it be installed or used in the following
kinds of places.
• Places where it will be directly exposed to rain or water (including under the eaves of a house)
• Places with a lot of steam or grease such as manufacturing plants or kitchens, places with special environments
such as those with combustible atmospheres
• Seaborne or coastal places and places where corrosive gases are given off
• Places where the operating temperature range of the electronic board (temperature: 10 °C to 35 °C [50 °F to 95 °F],
humidity: 30 % to 80 %) will be exceeded
(2) To prevent deformation and discoloring, avoid installing the unit in places exposed to direct sunlight or near heating
or cooling appliances, etc.
4.2.
Minimum Space Requirements
Make sure that the location is large enough to accommodate the elite Panaboard.
• UB-T580
Height: Greater than 2,300 mm (7 ft. 6.56 in.)
Width: Greater than 1,800 mm (5 ft. 10.87 in.)
• UB-T580W
Height: Greater than 2,300 mm (7 ft. 6.56 in.)
Width: Greater than 2,000 mm (6 ft. 6.75 in.)
13
Advertisement
Table of Contents
