Table of Contents
Advertisement
RAPT Pill Hydrometer & Thermometer Quick Start Guide
•
Fully Charge the Li-ion battery after installation before first time use by plugging a USB-C
cable into the USB-C charging port on the circuit board until the RED charging LED turns
off. This allows the device to calibrate and correctly determine the remaining battery
charge.
•
Incorrect battery orientation can damage the circuit board.
•
Always leak test your RAPT Pill by submerging in water prior to sanitising and dropping in
your fermenter
•
Only use KegLand approved cleaners such as
such as
StellarSan
The battery will come pre-installed in the RAPT Pill with a non-conductive strip on each terminal to
prevent the device from being activated during transit. Before plugging the device into power, you
will need to remove the battery and remove the two non-conductive strips from the terminals. Then
reinstall the battery making sure you follow the (+) and (-) inscriptions on the battery and battery
housing to ensure you install the battery in the correct orientation.
Important: make sure you install the battery in the correct orientation. Incorrect battery
orientation can result in damage to the circuit board. This will not be covered by warranty.
3
18
Page
of
WARNINGS
or
Phosphoric
Acid.
Battery Installation
www.KegLand.com.au
StellarOxy
and
StellarClean
Last Updated 6/05/2022 16:49 PM
and sanitisers
Hide quick links:
Advertisement
Table of Contents
