Table of Contents
Advertisement
Restoring to the Factory Default Settings
If the settings have been forgotten and want to set the camera from the beginning, restore to the factory default settings.
It is recommended to use [System] > [Maintenance] > [Backup/Restore] on the Settings Page to create a backup file before
restoring the factory default settings (P. 83).
Important
If restored to the factory default settings, the camera will be unable to connect because the administrator account is also initialized. Use
the Camera Search Tool to configure the default settings.
Note
For the factory default settings, refer to P. 97.
Restoring to the Initial Settings from a Web Browser
Use [System] > [Maintenance] > [General] > [Initialization] > [Network Settings and Management Information] > [Do not
save] on the Settings Page (P. 81).
Restoring to the Factory Default Settings with the RESET Switch on the
Camera
If the IP address or the Administrator password on the camera is forgotten, operating the camera via the network is not
possible. In this case, press the RESET switch located in the camera's receptacle unit (P. 13) to initialize the camera.
Turn the camera off.
1
The camera does not have a power switch. In order to turn the camera on or off, connect or disconnect the power
supply cable.
Turn on the power while pushing the RESET switch, confirm that the POWER lamp lights up (green), and then
2
release the RESET switch after about five seconds.
The RESET switch is located in a recessed area. Push the switch using the tip of a pointed object such as a clip.
When the POWER lamp stops blinking (green), the reset procedure is complete.
96
Advertisement
Table of Contents
