Table Of Contents; Packaging List; Testing / Listing, Epa; Using This Manual - Whitfield Profile 20 FS-2 Installation And Operation Manual

CONGRATULATIONS!
When you purchased your new pellet stove, you joined the ranks of thousands of individuals whose
answer to their home heating needs, aesthetics, effi ciency and our environment. We extend our
continued support to help you achieve the maximum benefi t and enjoyment available from your
new pellet stove.
It is our goal at Lennox Hearth Products to provide you, our valued customer, with an appliance
that will ensure you years of trouble free warmth and pleasure.
Thank you for selecting a Whitfi eld

TABLE OF CONTENTS

Important Safety Information ........Page 2
Packaging List ................................Page 3
Testing / Listing, EPA .....................Page 3
Using this Manual ..........................Page 3
Planning Your Installation ..............Page 4
Selecting a Location .......................Page 4
Floor Protection .............................Page 4
Fireplace Warning Label .................Page 7
Clearances .....................................Page 6
Manufactured Home Installation ...Page 8
Installation ....................................Page 8
Venting Requirements ....................Page 10
Care and Operation ........................Page 19
Fuel ................................................Page 22
Routine Maintenance .....................Page 22
Specifi cations .................................Page 29
Component Defi nitions ..................Page 32
Wiring Diagram ..............................Page 32
Troubleshooting .............................Page 33
Replacement Parts List & Diagrams ..Page 35
Optional Accessories ......................Page 41
Safety / Listing Label & EPA Label .Page 42
Installation Tips ..............................Page 44
Simple Operating Instructions .......Page 45
Ownership Records ........................Page 46
This installation and operation manual will help
you obtain a safe, effi cient, dependable instal-
lation for your appliance and vent system.
PLEASE READ AND UNDERSTAND
THESE INSTRUCTIONS BEFORE
BEGINNING YOUR INSTALLATION
®
stove as the answer to your home heating needs.

PACKAGING LIST

The assembled pellet stove and fi replace
insert models Profi le
FS-2 and Profi le 30 INS-2 are packaged with
an accessory package which contains the
following:
One - Installation and operation instructions
manual
One - Warranty
One - Power cord
One - Control board - Profi le 30 INS-2
only
One - Screw, #8 x 1/2" TEK (for mounting
control board) - Profi le 30 INS-2
only
One - Grate scraper
One - Lower trim
One - Wall thermostat w/ 20 foot roll of wire
One - Allen Wrench
Eleven - Screws, #8 (for hopper cover on insert
only)
One - Brush, Heat exchange tube - Profi le
30 Series only
Two - Leveling bolts, 1/4-20 x 3" - Insert
only
One - Fireplace Warning Label (insert only,
see Page 7)
Surround Kit (For Profi le 30 INS-2 Only)
(Purchased separately, see Page 41)
Kit is packaged with:
One - Top surround panel
One - Left surround panel
One - Right surround panel with door
One - Left side trim
One - Right side trim
One - Top trim
Two - Corner keys ("L" shaped brackets)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
LISTING / TESTING
Listing: The listing laboratory is ITS (Intertek
Testing Services) and the listing mark is
Warnock Hersey.
Testing: In accordance with the specifi cations
and procedures listed in UL 1482 / ULC S627
and ASTM E1509 for solid fuel room heater,
this appliance has been independently tested
to UL, ULC and CSA standards. UL 1482 / ULC
S627 states requirements for installations as
a free-standing room heater, hearth insert for
masonry fi replaces listed to UBC 37 or ULC
S628, or factory built (zero clearance) fi replaces
® listed to UL 127 or ULC S610. The safety / listing
20 FS-2, Profi le 30
label is located on an inside hopper surface of
the pellet stove. Please read this safety label
carefully. It contains important information
about installation and operation of this appli-
ance. This appliance is tested and listed for
residential installation according to current
national and local building codes as:
• A Free-Standing Room Heater - FS
• A (Fireplace) Insert Room Heater - INS
• A Manufactured Home Heater - FS & INS
EPA (Environmental Protection Agency)
Status: EPA Exempt - Pellet appliances that
are designed with the combustion air supply
exceeding the 35 to 1 (by weight) ratio are
exempt from EPA regulations and are "non-
affected facilities."

USING THIS MANUAL

Please read and carefully follow all of the
instructions found in this manual. Please pay
special attention to the safety instructions
provided in this manual. The homeowner's Care
and Operation Instructions included here will
assure you have many years of dependable and
enjoyable service from your appliance.
PRODUCT IS SUBJECT TO CHANGE
WITHOUT NOTICE
3