D-Link DKVM-IP16 Quick Installation Manual page 3

Press Home + Home
...then press Caps Lock
...then press
Scroll Lock
...then press
...then press
...then press
...then press
...then press
...then press
Note: Hot Keys can be achieved under OSD mode. Press Home + Home + Enter to enter
OSD menu.
Note: If you are using OSD, you can click directly when you are on the main menu. Because
under the OSD menu, you can press ↓ and ↑ keys to move the corresponding port. Then press
Enter key, the DKVM-IP16 will switch to this input.
Note: You can use Home + Home + F11 to reset the KVM switch.
Configuring the DKVM-IP16
The DKVM-IP16 default settings:
Username: super
Password: pass
DHCP: Disabled
IP address: 192.168.0.70
Subnet mask: 255.255.255.0
You can use a Web browser to configure the DKVM-IP16. The computer, which will be used for
configuring the KVM switch, should have an IP address in the same range as the DKVM-IP16. In
order to enter the Web-based GUI, please open a Web browser and enter the IP address of the
KVM switch in the address bar. Then press Enter. When the dialog box appears, enter the
username and the password. Press Login.
Note: Psetup software is used to set the network configuration and to find the DKVM-IP16 in the network.
Note: You can use the RS-232 serial port through the PuTTY software to restore the default password.
Note: You can remotely control the DKVM-IP16 using the 5.0 (V1.5) JRE (Java Runtime Environment)
program platform. You can download it from the following website: http://www.java.com/.
3
...
Num Lock
/ /
 2
...

or

or


Enter Hot Key mode by default
Enter Caps Lock Hot Key mode
Enter Scroll Lock Hot Key mode
Enter Num Lock Hot Key mode
Switch to PC1 / PC2 / ...
Switch to next PC
Switch to previous PC
Toggle the audible beep confirmations on and off
Start autoscan mode, which will switch to the next PC
automatically after scan interval expires (5 seconds
by default). Press any key to stop autoscan mode
DKVM-IP16