Advertisement
Excelis
HDMI
Using Excelis HDMI With a Monitor ONLY
The Excelis HDMI's on-board
software can be used with a PC,
Mac or stand alone HDMI monitor.
INSTALLATION
1) INSTALL THE CAMERA: Install the
c-mount adapter onto your Excelis
HDMI camera, then mount the camera
onto your microscope's photo port.
2) INSERT SD CARD: the SD card
was installed at the factory.
However, make sure your SD card is
inserted fully in the top of the camera –
the camera will not save images or video
without the SD card inserted and engaged.
3) CONNECT MOUSE: connect the mouse by
plugging it into the USB port on the top of the camera.
4) CONNECT HDMI CABLE: connect one end of the HDMI cable by plugging it into the HDMI
port on the top of the camera and the other end into the HDMI port on your monitor. Do not
connect the other end of the HDMI cable to the HDMI port on a PC or Mac.
5) CONNECT POWER CORD: plug the one end of the power cord into the 12VDC port on the
top of the camera and the other into a 120v AC outlet.
6) SET YOUR MONITOR SIGNAL TO HDMI: be sure to set your monitor's input signal to HDMI
to enable it to see your camera.
7) POWER ON THE CAMERA: (before turning on your camera, be sure your microscope is
turned on and light is going to your photo port) - press the ON/OFF (power) button on the top of
the camera – a blue light on the top will come on indicating the camera is ready. (The red light
indicates stand-by mode.
3
QUICK START
Advertisement
