This selection will cause the system to turn off the vertical and
V/H
horizontal synchronization ports and write blanks to the video buffer.
SYNC+Blank
Blank Screen This option only writes blanks to the video buffer.
Initial display power management signaling.
DPMS
Suspend Type
Select the Suspend Type.Configuration options: PWRON Suspend / Stop Grant
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU
will be shut off. Configuration options: Disabled / 1 Min / 2 Min / 4 Min / 8 Min / 12
Min / 20 Min / 30 Min / 40 Min / 1 Hour .
HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive will be
powered down while all other devices remain active.
Configuration options: Disabled / 1 Min / 2 Min / 3 Min / 4 Min / 5 Min / 6 Min / 7 Min
/ 8 Min / 9 Min / 10 Min / 11 Min / 12 Min / 13 Min / 14 Min / 15 Min
Soft-Off by PWR-BTTN : When set to delay 4 sec, the function allows the power button to
put the system in Suspend, a power saving mode. When set to Instant-off the Soft-Off
by PWR-BTTN function is disable and the computer turns completelyoff when the
power button is pressed.
Wake-Up by PCI card: Enable this selection to use the Wake up by PCI card.
Resume by Alarm
You can set "Resume by Alarm" item to enabled and key in Data/ time to power on
system.
Disable this function.
Disabled
Enable alarm function to POWER ON system.
If RTC Alarm Lead To Power On is Enabled.
Enabled
Date (of Month ) Alarm : Every day , 1~31
Time (hh: mm: ss) Alarm : (0~23) : (0~59) : (0~59)
FDD,COM,LPT Port
Configuration options: Enabled / Disabled
PWRON After PWR-Fail : Select Enabled, this setting will let the power switch always
under on-line status after commercial power back to normal.