Table of Contents
Advertisement
1.7. Memory Expansion Installation
*
Withdrawing the Main Circuit Board from the Printer
Be sure to remove the memory card first if inserted in the printer's memory
card slot.
Withdraw the main circuit board completely from the printer as follows:
1.
Turn the printer's power off. Unplug the printer's power cable and disconnect
the printer from the host computer.
2.
Remove the three screws from the
printer's rear cover.
3.
Pull the main circuit board all the way out
of the printer.
*
Before pulling the main board out,
clean an area on the table, etc., at
the back of the printer's rear panel.
Foreign objects, accidentally sticking
to the back of the main board, can
cause serious damage to the printer.
Install the SIMM as described on the next
page.
1-24
Power OFF
SIMM Sockets
š
(
)
Advertisement
Table of Contents
