Dispenser Contents; Basic Dosage - Siemens WM14UPI0DN User Manual And Installation Instructions

Table of Contents

Advertisement

If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers → Page 35.
Pull out the detergent drawer.
1.
Open the dispenser cover.
2.
Pour liquid detergent
3.
softener
into the relevant dis-
pensers.
→ "Detergent drawer", Page 18
Do not exceed the marking for the
maximum filling level when filling.
Close the dispenser cover.
4.
Note: To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
If required, add cleaning aids such
5.
as stain remover, water softener or
bleach into the compartment for
manual dosing.
→ "Adding detergent and care
product", Page 32
Push in the detergent drawer.
6.
7.
15.3 Dispenser contents
Notes
¡ If you change the contents of the
¡ If you use both dispensers for li-
Adjusting the dispenser contents
1.
2.
and fabric
a The display shows
3.
4.
15.4 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
Adjusting the basic dosage
1.
a The display shows the basic
2.
3.
Note: To adjust the basic dosage for
Intelligent dosing system en
Adjust the basic dosage
→ Page 35.
dispenser, the basic dosage for
this dispenser is reset.
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Press and hold
3 seconds.
To set
, press
To set
, press
To end the setting process, wait
briefly.
Press and hold
prox. 3 seconds.
dosage set for
To adjust the setting, press
To end the setting process, wait
briefly.
, repeat the steps with
i-Dos for approx.
i-Dos.
.
i-Dos again.
 i-Dos for ap-
.
/
i-Dos.
35
.

Advertisement

Table of Contents
loading

Table of Contents