Mitsubishi Electric MELSEC FX Series User Manual page 36

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
Requirement for Compliance with LVD directive
The following products have shown compliance through direct testing (of the identified standards below)
and design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (2006/95/EC) when used as directed by the appropriate documentation.
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX
from November 1st, 2008
from December 1st, 2008
from March 1st, 2009
from December 1st, 2009
EN61131-2:2003 Programmable controllers
Models : MELSEC FX
from July 1st, 1997
from April 1st, 1998
from August 1st, 1998
from August 1st, 2005
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-
2:1994+A11:1996+A12:2000 after May 1st, 2006 are compliant with EN61131-2:2003
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
EN61131-2:1994 Programmable controllers
/A12:1996 - Equipment requirements and tests
/A11:2000
EN61131-2:2003 Programmable controllers
series manufactured
3G
FX - MT/ES
3G
Where indicates:14,24,40,60
FX - MR/ES
3G
Where indicates:14,24,40,60
FX - MT/ESS
3G
Where indicates:14,24,40,60
FX - MR/DS
3G
Where indicates:14,24,40,60
Standard
- Equipment requirements and tests
series manufactured
2N
FX - ER-ES/UL
2N
Where indicates:32,48
FX -16EYR-ES/UL
2N
FX -48ER-DS
2N
FX -48ER-UA1/UL
2N
FX -8ER-ES/UL
2N
Standard
and laboratory use
- General requirements
- Equipment requirements and tests
The equipment has been assessed as a component for fitting in a suitable
enclosure which meets the requirements of EN61131-2:2003
FX - ET-ESS/UL
2N
FX -8EYR-ES/UL
2N
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of IEC 1010-
1:1990+A1:1992
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of EN61131-
2:1994+A11:1996+A12:2000
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of EN61131-2:2003
Standards
Remark
Remark