Table of Contents
Advertisement
7.0
INSTALLATION INSTRUCTIONS
7.1
NCP-DVR2K INSTALLATION
1.
OPTIONAL: Select the electrostatic film from the
box and install it on the front windshield in the
recommended position as in the illustration.
Please wipe the glass before installation and push
out the bubbles between the static film and the glass
before installation.
2.
Remove the protective film off the NCP-DVR2K mount and position the Dash Camera in
the middle of the electrostatic film (optional). Press down on the base of the bracket by
hand for 30 seconds to ensure that the adhesive mount is attached to the electrostatic
film, adjust the camera by rotating the barrel until it is capturing the entire road.
3.
Run the dash camera cable along the top of the
front windshield through the A pillar and around and
under the storage compartment of the passenger
seat to the car's 12/24V adaptor port. Connect the
12/24V adaptor to the car power.
NOTE:
• The electrostatic film helps for easy removal of the dash camera from the windshield.
Included in package contents.
7
Advertisement
Table of Contents
