Kenwood KRC-666 Instruction Manual page 39

Cassette tape source
?
Can't remove tape.44
The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
The tape can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?
The DPSS and Music Repeat don't operate
The space between the songs on the tape can't be recognized
because it's too short.
Have at least 4 seconds between songs.
The space between songs can't be recognized because there's too
much noise between songs.46
Reduce the noise between songs.
?
The blank skip doesn't work.47
Because noise is too loud, the non-recorded part can't be recognized.
Reduce the noise between songs.
?
Blank Skip functions at places that are
Because the recording level is low, it's recognized as not recorded.
Turn Blank Skip OFF.
?
<Music repeat> (page 19) is cancelled arbitrarily.
The power was turned OFF or a source selection or other operation
was performed.
Music repeat is cancelled when the power is turned OFF or a
source selection or other operation is performed.
correctly.45
recorded.48
— 39 —
Disc source
?
"AUX1" is displayed without achieving External disc control
Unsupported disc changer is
Use the disc changer mentioned in the IMPORTANT
INFORMATION of the section on <Safety precautions>(page 3).
?
The specified disc does not play, but another one plays
The specified CD is quite dirty.
Clean the CD.
The disc is loaded in a different slot from that
Eject the disc magazine and check the number for the specified
disc.
The disc is severely scratched.55
Try another disc instead.
?
Direct Search can't be done.66-1
Another function is ON.
Turn Random Play or other functions OFF.
?
Track Search can't be done.66-2
For the discs/folders first or last song.
For each disc/folder, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
song.
If the following situations, consult your nearest service
center:
Even though the disc changer is connected, the Disc Changer source is not
ON, with "AUX1" showing in the display during the Changer Mode.
mode.50
connected.51
instead.52
specified.54