Table of Contents
Advertisement
Quick Start
Interface Connectors
Interface Connectors
The following are the Adit 3200 interface connectors:
Front of Adit
(1) DS1 WAN port (RJ-48C). Note: E1 will be in a future release.
(1) 10/100Base-T WAN port (RJ-45)
(4) 10/100Base-T switched LAN ports (RJ-45)
Back of Adit
RS-232 craft port connector for local management
Power input connector
Ground connector
Grounding the Unit
WARNING!
PROTECTION OF USERS AND SERVICE PERSONNEL
Chassis ground is located on the back of the unit.
To ground the unit:
1. Connect a minimum 14 AWG ground
wire with a #8 ring tongue terminal (not
included) to the chassis ground on the
back of the unit. Secure with the 8-32
screw and lock washer provided.
2. Connect the opposite end of the ground
wire to a suitable earth grounding point
such as a building grounding electrode,
metal water pipe, or metal building
structure that is in compliance with article 250 of NEC.
12
T
A
3200
HE
DIT
IS REQUIRED TO BE PERMANENTLY GROUNDED FOR THE
.
Chassis
Ground
Adit 3200 - Release 1.6
Advertisement
Table of Contents
