ABB SPAF 140 C User Manual And Technical Description page 39

Control parameters
Measured value
Remote resetting of recorded data
Remote control of setting
Event mask for stage 1
Event mask for stage 2
Event mask for stage 3
Event mask for stage 4
Event mask for output signals
Event mask for output relays
Event mask for recovery function
Opening of password
Changing or closing of password
Activation of self-supervision system
EEPROM formatting
Address of relay module
Data transfer rate
Program version
Reading of event register
Re-reading of event register
Type designation of relay module
Reading of relay module status data
Resetting of module status data
Reading and setting of time
The event register can be read only once using
the L code. Should a fault occur, say, in the data
transfer, the B command can be used to re-read
the contents of the register. When required, the
B command can be repeated. In general, the
control data communicator reads the event data
Code Data Value
direction
V102 W 1 = resetting
V150 R,W 0 = main settings active
1 = second setting active
V153 R,W 0...63, see "Event codes"
V154 R,W 0...63, see "Event codes"
V155 R,W 0...63, see "Event codes"
V156 R,W 0...63, see "Event codes"
V157 R,W 0...255, see "Event codes"
V158 R,W 0...255, see "Event codes"
V159 R,W 0...31, see "Event codes"
V160 W 1...999
V161 W(P) 0...999
V165 W 1 = self-supervision
V167 W(P) 2 = formatting
V200 R,W 1...254
V201 R,W 4800 or 9600 Bd
V205 R 131_
L R Time, channel number
and event code
B R Time, channel number
and event code
F R SPCF 1D15
C R 0 = normal status
1 = module been subject to
2 = overflow of event register
3 = events 1 and 2 together
C W 0 = resetting
T R,W 00.000...59.999
and forwards the information to an output de-
vice. Under normal conditions the event regis-
ter of the relay module is empty. The control
data communicator also resets abnormal status
data, so this data is normally zero.
activated and IRF LED is lit
automatic reset
25