Advertisement
To Operate the Arctic
Pedestal Fan
Plug the cord into a 230V or 240V power
point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit as your fan when it
is in use.
Use the Twist Controller Switch to select
the desired air flow speed setting.
0 – The fan is in the 'OFF' position
1 – Low
2 – Medium
3 – High
Setting the Oscillation
The oscillation function works in all air
flow settings.
Press down the Oscillation switch to
activate. The fan will begin to oscillate
from side to side.
Lift the Oscillation switch to stop the fan
from oscillating.
Fig. 2
NOTE: The Oscillation switch is
located behind the Rear Grille,
on the Motor head housing.
Adjustable Tilting Head
The Arctic Pedestal Fan incorporates
an Adjustable Tilt Head for greater
air coverage.
To adjust the angle of the head, while
securely holding the shaft of the
pedestal tube, simply lift or lower the
Motor head housing, the head will click
as it is being adjusted.
Adjustable Height
The Arctic Pedestal Fan height can be
adjusted.
Simply loosen the Height Adjustable Ring
on the Pedestal Tube of the fan. Then
adjust to the required height. Re-tighten
the Height Adjustable Ring when the
desired height has been reached.
Care and Maintenance
Always switch the Arctic Pedestal Fan
off, prior to cleaning the housing, base,
grilles and blades.
To clean the outside of the fan, wipe
the exterior with a soft, damp cloth.
Never use an abrasive cleaner.
When not in use, store the fan
Fig. 3
(preferably in its original box) in a cool,
clean and dry location.
7
Advertisement
