Setting The Video Channel; The Video Cassette - JVC VIDEO CASSETTE PLAYER HR-JP34K Instructions Manual

Setting the video channel

To watch videos on your TV, it must be set to the same UHF
channel as the video cassette player. This channel is used as
the video channel.
This video cassette player has been preset to UHF channel 36.
Note:
When you have connected the VIDEO/AUDIO OUT termi-
nals of this video cassette player to your TV's video/audio in
terminals (connection B of the "Connections" section), set-
ting the video channel is not necessary. In this case simply
set the TV's TV/VCR switch to VCR.
1 Turn the video cassette player's power on and load a
pre-recorded video tape.
Turn on the TV and set it to UHF channel 36.
2
If UHF channel 36 is being used for broadcasting in
your area:
Adjust the TV's channel selector a little at a time until the TV
screen is blank (set it towards a higher or lower channel).
Adjust the RF channel adjustment screw on the rear panel
of the video cassette player a little at a time until the
playback picture appears on the TV screen.
4 )
3 2 ( 2
7 )
4 0 ( 2
Higher channel
If the TV's channel selector was set to a higher channel
than channel 36, turn the RF channel adjustment screw
to the left and vice versa.
3
Adjust the TV picture with the TV's tuning controls.
Using the TV while the video
cassette player is connected
To watch a normal TV broadcast, select a TV station with
the TV's channel selector.
6
Lower channel

The video cassette

Inserting a cassette
STANDBY/ON
VIDEO CASSETTE
PLAYER
HR-JP34K
MIC DIGITAL ECHO
SP/LP/EP
1 MIC 2
MIN MAX 0 10
KARAOKE MULTI LONG PLAY RECORDING
7 SUPER HEAD CLEANER
STANDBY/ON
VIDEO CASSETTE
PLAYER
HR-JP34A
MIC
1 MIC 2 SP/LP/EP
MIN MAX
7 Insert the cassette as shown and push it gently into the
video cassette player.
The video cassette player will be turned on automatically and
the cassette will be loaded.
7 Press the Stop/Eject § button to eject a cassette.
During playback or recording, press the § button twice
(once to stop the tape and once more to eject it).
Notes:
If the cassette's safety tab has been removed, playback will
start automatically when the cassette is inserted.
A cassette can also be ejected when the power is off.
The POWER-ON indicator blinks while the cassette is ejected.
Special note on Video Cassettes
To prevent accidental recording on a recorded cassette, re-
move its safety tab. To record on it later, cover the hole with
adhesive tape.
NTSC
PLAYBACK
ON PAL TV
B.E.S.T POWER-ON LP / EP
NTSC
4.43
STANDBY / REC B.E.S.T.
PAL NTSC
NTSC 3.58
7 AUTO VOLTAGE 7 PAL / MESECAM / NTSC 3.58 / 4.43
NTSC
DIGITAL ECHO
PLAYBACK
ON PAL TV
B.E.S.T POWER-ON LP / EP
NTSC
4.43
STANDBY / REC B.E.S.T.
PAL NTSC
0 10 NTSC 3.58
Safety tab