Toro Greensmaster Flex 2120 Operator's Manual page 14

Service Brake
The service brake (Figure
front side of the handle. Pulling back the lever applies
the service brake.
You must disengage the brake before you engage the
traction drive. If you operate the machine with the
brake engaged, the machine moves, but with a high
resistance and increased power consumption.
Figure 18
1. Parking-brake latch
Parking-Brake Latch
Use the parking-brake latch
service brake. Rotate the parking-brake latch toward
the brake handle to hold the service brake in place.
Pull the brake lever to release.
Note:
You cannot move the traction-control lever
while the latch is engaged.
On/Off Switch
The On/Off switch (Figure
the control panel. Move the switch to the O
to start the engine and the O
the engine.
Operator-Presence Control (OPC)
You must engage the operator-presence control
(Figure 15) before you engage the traction lever. If you
release the OPC during operation, the traction lever
returns to neutral and the engine continues to run.
18) is located on the left
2. Service brake
(Figure 18) with the
15) is located on the top of
position
N
position to shut off
FF
Choke Lever
The choke lever
of the engine. Use the lever to aid in starting a cold
engine; refer to
1. Choke lever
2. Fuel-shutoff valve
Fuel-Shutoff Valve
g016853
The fuel-shut-off valve is located on the side of the
engine below the choke control
Note:
Close the fuel-shutoff valve when the machine
is not used for a few days, during transport to and
from the job site, or when the machine is parked
inside a building; refer to
Fuel-Shutoff Valve (page
14
(Figure 19) is located on the left front
Using the Choke Lever (page
Figure 19
3. Recoil-starter handle
(Figure
Opening and Closing the
22).
22).
g265059
19).