Troubleshooting - JVC LVT1286-003A Instructions Manual

Troubleshooting

When you encounter a problem that seems to be a
fault, check the following points before contacting
your JVC service center:
Power source
7 Power does not come on.
• The power cord is not connected to the main
unit or an AC outlet.
→
Connect the power cord correctly.
(A page 11)
Operation
7 You cannot operate any button.
• Some specific operations may be inhibited
for some discs.
7 The remote control does not work.
• The dry-cell batteries have run out.
→
Replace the batteries. (A page 6)
7 A disc cannot be played back.
• In the case of DVD VIDEO discs
→
Check the Region Code number of the
disc. (A page 3)
• "PLAYABLE Err" is displayed on the display
window.
It is not a disc that can be played on this
system.
→
Check the disc type. (A page 3)
• Parental Lock is set. (A page 30)
About images
7 No picture appears.
• The SCART cable is not connected correctly.
A page 11
→
7 The picture is distorted.
• A VCR is connected between the main unit
and the TV set.
→
Connect the main unit directly to the TV
set. (A page 11)
7 The screen size is abnormal.
• The screen size is set improperly.
→
Set "MONITOR TYPE" according to the TV
set you are using. (A page 29)
40
7 The TV screen darkens.
• "SCREEN SAVER" is set.
→
If set, press any button. (A page 29)
About sound
7 There is no sound.
• Speakers are not connected correctly.
A page 9
→
• The sound is muted.
A page 16
→
• "NO AUDIO" is displayed on the display
window.
The disc may have been produced through
illegal copying.
→
Confirm at the store where you bought the
disc.
7 The sound is weak compared with TV or Video.
• "DVD LEVEL" is set to "NOR".
→
Set to other than "NOR". (A page 26)
7 The sound is distorted.
• The volume is turned up too high.
→
Turn down the volume. (A page 16)
7 No sound comes out of the subwoofer.
• "SUB WFR" is turned off.
→
Press S.WFR OUT to turn on.
(A page 10)
About radio
7 The sound is noisy while receiving./Receiving
is disabled.
• The antenna is not connected correctly.
→
Connect the antenna correctly.
(A page 8)