D-Link E15 Quick Installation Manual

Quick Installation Guide
E15
AX1500 Wi-Fi 6 AI Mesh Range Extender
INSTALLATION
OPTION 1
QUICK WPS SETUP
1
Plug the E15 into a power source near your wireless router. Wait for
the Status LED to flash orange.
/
2
Press the WPS button on your router for 3 seconds. Refer to your
router's manual for router behaviour.
/
3
Press the WPS button on your E15 for 3
/ seconds. The status LED should start to
flash white.
4
When the Status LED turns solid white
/ (may take up to 3 minutes), this indicates
that your E15 is connected to your
wireless router.
Your setup is complete! You can now unplug and move your device to
a location between your router and the area where you want wireless
coverage. By default, your device will share the same Wi-Fi name and
password as your router.
IMPORTANT
WPS may be disabled on some Routers or Modems. If the WPS Status
LED on your Router or Modem does not start blinking when you have
pressed the WPS button, try again and hold it a little longer. If it still
does not blink, STOP, and configure your E15 using
Option 2: D-Link Ai App Setup.
PACKAGE CONTENTS
• E15 || AX1500 Wi-Fi 6 AI Mesh Range Extender
• Ethernet Cable
• Quick Installation Guide
• Quick Installation Card
OPTION 2
D-LINK AI APP SETUP
1
Download the D-Link Ai app and launch it.
/
D-Link Ai
2 Tap Install New Device. Scan the Setup code on the Quick
Installation Card. Follow the on-screen instructions to complete
/
the setup.
D-Link Ai
Quick Installation Card
"D-Link Ai "
SETUP QR CODE
Model Name: DEVICE
Wi-Fi Name: dlink-XXXX
Password: XXXXXXXX
S/N: 123456789