Table of Contents
Advertisement
NEVER PLACE LIMBS UNDER THE MACHINE WHILE ROTOR(S) ARE TURNING. ROTORS CAN REMAIN
TURNING FOR UP TO 1 MINUTE AFTER TURNING OFF THE HYDRAULIC MOTOR .
Workstation
The operator must remain seated while working the machine. If the machine is a winged unit and the wings need to be
raised/lowered the operator must not leave the tractor. Never leave the workstation (tractor cab, digger cab) with the
hydraulic motor running and blades rotating. Always apply the handbrake and turn off the hydraulic motor before leaving
the cab.
NEVER OPERATE THE HYDRAULICS WITH THE TRACTOR SWITCHED OFF
Regulations for use of the transmission
The transmission between the gearboxes is protected by a bolt down cover. All guarding should be kept efficient and in
good condition. If the condition is poor, the guarding should be replaced before the implement is used. It is the operator's
responsibility to check the condition of the covers before each use.
UNLESS IT IS CORRECTLY PROTECTED THE TRANSMISSION COULD CAUSE DEATH SINCE IT CAN
CATCH ON PARTS OF THE BODY OR CLOTHING
Driving Safely on Public Roads
Check the local Highway Code regulations before driving the tractor on public highways with an implement attached.
Check the reflectors, hazard flashers and/or projecting load indicators are installed when required and efficient. These
indicators must be installed correctly and easily seen by the drivers of other vehicles.
Bystanders must not be allowed to lean against or climb onto the machine during transport or while working. Do not
allow bystanders to ride on the machine.
Maximum transport speed of the implement is limited to 25-30km/h depending on the model of the machine
(observe safety labels on the machine).
General safety instructions
Precautions to be taken while working with the machine:
1. Do not operate the machine when you are tired or under the influence of alcohol or any other intoxicant;
2. Before starting mowing, make sure that the area is clear of people or animals.
3. It is mandatory to read all the safety requirements and the operator's manual of the machine.
4. If you are not sure how to use the machine, please contact the manufacturer or the dealer.
4
www.major-equipment.com
Advertisement
Table of Contents
