Table of Contents
Advertisement
Operating the Machine/Mowing
Never place limbs under the machine while rotors are turning. Always operate on level ground when
connecting/disconnecting the implement. This will prevent dangerous movement.
1. Move the machine into mowing position;
2. Use spool to raise/lower front hood according to material being cut.
Roller adjustment
In order to achieve desired cutting height, the roller should be adjusted.
Roller
To adjust the height of the roller follow this procedure at both
sides of the roller:
1. Loosen Bolt C (Note: You do not have to remove the bolt,
half of the turn will suffice to allow movement);
2. Remove Bolt B and locate in the desired slot A. (Note: Pay
attention when removing Bolt B as the roller may swing
down, adequate support must be provided under the roller);
3. Match the height of the roller on both sides of the machine
by checking the position of Bolt B in slot A;
4. When adjustment is complete, re-tighten Bolts B and C.
www.major-equipment.com
C B
A
13
Advertisement
Table of Contents
