Time Setting; Temperature Setting - Saunacore Steamcore Pro Series Installation Manual & Owner's Manual

When the actual temperature is smaller than or equal to 32 , the
digital tube will display 32
smaller than or equal to 140
140 . The last digit displays
temperature. The default start time of steam function is 30
minutes. When the steam is starting, there is a shortage of water,
the heating wire will stop heating and the water input valve will
start automatically. If there is no water tested in 5 seconds or no
water coming to reach the full volume in 15 seconds, the digital
tube will flash to display
If the water is full, the steam function will return to normal.
When the steam function is started, if the temperature of the
environment is higher than the set steam temperature, the
heating wire will stop heating, the digital tube will flash to
display the current environment temperature; when the
e n v i r o n m e n t t e m p e r a t u r e i s l o w e r t h a n t h e s e t s t e a m
temperature, the heating wire will restore heating, the digital
tube will display normally current environment temperature.
When the system is started, press
steam function time is due, the system will be shut. 10 minutes
after the system is shut off, the drainage function will be started
automatically for 5 minutes.

Time setting

When the machine is started, press
will display the remaining time of current steam function (as
shown in Fig.4), press
remaining time. The adjustment range is 1-99 minutes with 1
minute as one level. If there is no adjustment in 5 seconds, the
system will quit the time setting function. The digital tube will
restore to display current environment temperature.

Temperature setting

Whenthemachine is started,press
will display the set steam time (as shown in Fig.5), at the same
time the temperature unit will flash to hint that the machine has
entered the steam temperature setting function. At this time, press
button or button to adjust the temperature parameter.
The adjustment range is 50-130 with 1 as one level. If there is
no adjustment in 5 seconds, the system will quit the temperature
setting function. The digital tube will restore to display current
environment temperature.
. When the actual temperature is
, the digital tube will display
as the unit of Fahrenheit
(as shown in Fig.3) to hint mistake.
button and the digital tube
button or button to adjust the
button and the digital tube
23
User Manual
button or when the
Fig 2
Fig.3
Fig.4
Fig.5