Select The Video Input To Be Projected - JVC G1000S Instructions Manual

Basic Operations (Cont.)
Projector's buttons
STAND BY
LAMP
TEMP
EMERGENCY
VIDEO
COMPUTER
SETTING
+ 3
QUICK
ALIGN.
- 2
Remote control unit
OPERATE COMPUTER VIDEO
VOL. FOCUS
MENU/ENTER
PAGE
BACK
PRESET
QUICK AV
ALIGN. MUTING
ATTENTIONS
• DO NOT give any shock to this projector while
operating it; otherwise, the light-source lamp goes off
(the EMERGENCY indicator lights up).
If the shock turns off the light-source lamp —
Turn off the power by pressing the MAIN POWER
switch, then turn it on again. Now you can operate
the projector as usual.
G1000S 26-33.EN
VIDEO button
COMPUTER button
COMPUTER button
VIDEO button
27

2. Select the video input to be projected

Press the VIDEO button or the COMPUTER button to
switch the input.
• Each time you press either button, the selected input changes as
follows.
When you press VIDEO:
Y/C
When you press COMPUTER:
COMPUTER1
Remote control unit
COMPUTER VIDEO
Screen display
V I D E O
* When the input is switched, the line display (ex. VIDEO) and
the source display (ex. NTSC) are shown on the upper part of
the screen (they disappear in about five seconds). However,
they will not be shown if LINE DISPLAY in "Setting and Adjusting
Other Functions (OPTIONS)" on page 43 is set to OFF.
(For setting the source, see page 46.)
Note
• To select the proper audio input for video input
The video input terminal (AV IN input terminal) can be switched with the
VIDEO button. However, since this projector has only a single audio input
terminal, reconnect audio input in accordance with the AV device to be used.
98.9.21, 9:53 AM
VIDEO Y,P /B-Y,P /R-Y
B R
COMPUTER2
Projector
VIDEO
COMPUTER
N T S C
27