Description; Purpose; Overview; Safety - GreenWorks CSF401 Operator's Manual

1

DESCRIPTION

1.1

PURPOSE

This chainsaw is designed for cutting branches, trunks, logs
and beams of a diameter determined by the cutting length of
the guide bar. It is only designed to cut wood.
It is only to be used in an outdoor, domestic application by
adults.
Do not use the chainsaw for any purpose not listed above.
This chainsaw is not to be used for professional tree services.
It is not to be used by children or by persons not wearing
adequate personal protective equipment and clothing.
1.2

OVERVIEW

Figure 1-22
Guide bar cover
1
Front handle guard / chain brake
2
Front handle
3
On/off switch
4
Lock out button
5
Trigger
6
Oil indicator
7
Oil tank cap
8
Saw chain
9
10 Guide bar
11 Rear handle
12 Spike bumpers
13 Chain tension knob
14 Chain cover
15 Chain cover knob
16 Bolt for saw chain tension
17 Sprocket
18 Bar guide
19 Oil outlet
20 Bar groove
21 Chain drive links
22 Cutter
23 Felling direction
24 Danger zone
25 Escape route
26 Direction of fall
27 Notch
28 Felling back cut
29 Hinge
30 Limb cut
31 Keep work off ground leave support limbs until log is
cut
32 Log supported along the entire length
33 Cut from top (over buck) avoid cutting earth
English
34 Log supported one end
35 Under buck
36 Over buck
37 Log supported both ends
38 Bucking a log
39 Stand on uphill side when cutting because log may roll
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the battery pack until you assemble all the
parts.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
5
WARNING
WARNING
WARNING
WARNING
WARNING
EN