Makita DLS110 Instruction Manual page 33

Troubleshooting for wireless activation function
ment parts for repairs.
State of abnormality
celling tool registration successfully.
Probable cause (malfunction)
the tool.
into the tool.
the slot is dirty.
tool has not been pushed.
No power supply
-
the tool.
into the tool.
the slot is dirty.
No power supply
Incorrect operation
from each other (out of the transmission
range).
cancellation;
- the switch trigger on the tool is pulled
or;
- the power button on the vacuum
cleaner is turned on.
Radio disturbance by other appliances
which generate high-intensity radio
waves.
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
Push the wireless activation button on the tool
Set the stand-by switch on the vacuum cleaner to
Supply the power to the tool and the vacuum
cleaner.
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
Set the stand-by switch on the vacuum cleaner to
Supply the power to the tool and the vacuum
cleaner.
again.
Get the tool and vacuum cleaner closer to each
approximately 10 m however it may vary according
to the circumstances.
again.
Perform the tool registration procedures for both the
tool and the vacuum cleaner at the same timing.
Keep the tool and vacuum cleaner away from the
appliances such as Wi-Fi devices and microwave
ovens.
33 ENGLISH
-