Installation; Functional Description - Makita DLS110 Instruction Manual

Fig.3
1 Switch trigger
5 Switch (for laser line)
(For DLS111, DLS112
only)
9 Wireless activation
button
13 Guide fence (lower
fence)
17 Bevel angle scale
21
bevel angle)

INSTALLATION

Installing the grip
Screw the threaded shaft of the grip into the turn base.
Fig.4: 1. Grip 2.
Installing the dust extraction hose
Connect the dust extraction hose to the tool as
illustrated.
the ports of the tool.
Fig.5: 1. Dust extraction hose 2. Elbow 3. Sleeve
4. Port
Bench mounting
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. While lowering the
handle slightly, pull the stopper pin and rotate it 90°.
Fig.6: 1. Locked position 2. Unlocked position
3. Stopper pin
stable surface using the bolt holes provided in the tool's
Fig.7: 1. Bolt
WARNING:
Ensure that the tool will not move
on the supporting surface. Movement of the miter
saw on the supporting surface while cutting may
2 Lock-off button
6 Battery indicator
10 Wireless activation lamp
14 Guide fence (upper
fence)
18 Releasing lever (for 48°
bevel angle)
- -
3 Hole for padlock
7 Mode indicator
11 Hose (for dust
extraction)
15 Dust bag
19 Latch lever (for bevel
angle)
- -
FUNCTIONAL
DESCRIPTION
WARNING:
switched off and the battery cartridge is removed
before adjusting or checking the functions on
the tool. Failure to switch off and remove the battery
accidental start-up.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
cartridge. Failure to hold the tool and the battery
and result in damage to the tool and battery cartridge
Fig.8: 1. Red indicator 2. Button 3. Battery cartridge
while sliding the button on the front of the cartridge.
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE:
cartridge.
21 ENGLISH
4 Lid (for wireless unit)
(For DLS111 only)
8 Check button
12 Stopper pin (for carriage
elevation)
16
bevel angle)
20 Pointer (for bevel angle)
-
Always be sure that the tool is
-