Maintenance And Care - Eco GFI-1202 User Manual

Automatic water supply station /
GFI-1202 / GFI-1202IN
CAUTION!
Danger of injury from hot water
In extended use against the closed pressure side (>10 min.), the water in the pump can be
severely heated up and can be emitted in an uncontrolled manner! Isolate the unit from the mains
and allow the pump and water to cool down. Start the unit again only after all the faults have been
rectified!
The risk of injury from hot water can arise if:
the installation is not correct
the pressure side is closed off
there is a lack of water in the suction line, or if
the pressure switch is defective.
Procedure
1. Isolate the unit from the mains and allow the pump and water to cool down.
2. Check the unit, the installation and water level.
3. Start the unit again only after all the faults have been rectified!

MAINTENANCE AND CARE

CAUTION!
The pump must be isolated from the mains before any maintenance and service work. Remove
the mains plug from the plug socket.
Flushing the pump
After conveying swimming pool water containing chlorine or fluids that leave a residue the pump must be
flushed out with clear water.
Remove blockages
1. Isolate the unit from the mains and secure against switching on again.
2. Remove the suction hose from pump inlet.
3. Connect the pressure hose to the water supply.
4. Allow water to run through the pump housing until the blockage is removed.
5. Check that the pump is running freely by switching it on briefly.
6. Start the house water system again as described.
STORAGE
1. Drain the suction and pressure lines.
2. Unscrew the drain screw and allow the water to flow out of the pump.
3. Screw the drain screw back in place and store the pump and accessories in a frost-free
environment.
6