JVC GR-D370AH Instructions Manual page 49

Picture does not appear on the LCD monitor.
The viewfinder is pulled out and "PRIORITY" is
set to "FINDER".
➜Push the viewfinder back in or set "PRIORITY" to
"LCD". ( pg. 20, 32, 34)
The LCD monitor's brightness setting is too dark.
➜Adjust the brightness of the LCD monitor.
( pg. 18)
➜If the monitor is tilted upward 180 degrees, open
the monitor fully. (
An error indication (01 – 04 or 06) appears.
A malfunction of some kind has occured. In this
case the camcorder's functions become
unusable.
➜
pg. 50.
The remote control does not work.
"REMOTE" is set to "OFF".
➜Set "REMOTE" to "ON". (
The remote control does not point at the remote
sensor.
➜Point at the remote sensor. (
The remote control batteries are exhausted.
➜Replace the batteries with fresh ones. (
Warning Indications
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
Appears if a tape is loaded.
Blinks when no tape is loaded.
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to
"SAVE" while the Power Switch is set to "REC"
and the VIDEO/MEMORY Switch is set to
"VIDEO". ( pg. 16)
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
( pg. 52)
pg. 20)
pg. 32, 34)
pg. 25)
pg. 25)
Exhausted
TROUBLESHOOTING
CONDENSATION, OPERATION
PAUSED PLEASE WAIT
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
TAPE!
Appears if a tape is not loaded when the
Recording Start/Stop Button or SNAPSHOT
Button is pressed while the Power Switch is set
to "REC" and the VIDEO/MEMORY Switch is set
to "VIDEO".
TAPE END
Appears when the tape ends during recording or
playback.
SET DATE/TIME!
Appears when the date/time is not set.
( pg. 17)
The built-in clock battery has run out and the
previously set date/time has been erased.
Consult your nearest JVC dealer for
replacement.
LENS CAP
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
A. DUB ERROR!
Appears if Audio Dubbing is attempted on a
blank portion of a tape. (
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED TAPE>
<CANNOT DUB ON A 16BIT RECORDING>
<CHECK TAPE'S ERASE PROTECTION
TAB>
Appears if Audio Dubbing is attempted on a
tape recorded in the LP mode. (
Appears if Audio Dubbing is attempted on a
tape recorded in 16-BIT audio. (
Appears if A. DUB (
is pressed when the erase protection tab is set
to "SAVE". ( pg. 46)
EN
pg. 46)
pg. 46)
pg. 46)
) on the remote control
49