Table of Contents
Advertisement
ENTER
INPUT
5
Fine-adjust the track marking position by
pressing </4 or ¢/>.
The track marking position can be fine-adjusted in the
range of ±128 positions (approx. ±8 sec.).
As you press the button, the track marking displaces
slightly and the 3-second section from the newly divided
point will be played repeatedly.
• After completing the fine-adjustment, go to step 6.
To correct a previously fine-adjusted track marking
position:
1 Press CANCEL.
2 Select the track number by pressing </4 or ¢/>
and press £.
3 Return to step 4.
6
Press ENTER.
The change made above is entered temporarily in the
memory. The display shows "EDITING".
Press 0 to eject the MD.
7
The data in the memory is written in the MD before it is
ejected.
The display shows "UTOC writing" during MD write
operation.
• Be careful not to apply impact to the MD recorder
during writing data in the memory in the MD.
Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also
when the power is switched to the STANDBY mode
while "EDITING" is being displayed.
To exit editing:
Press EDIT before pressing ENTER in step 6 .
To restore the original track from the divided
tracks:
Use the JOIN editing function.
See "Joining tracks (JOIN)" on page 30.
1 2 3 4 5
6 7
29
XM-EX90
Advertisement
Table of Contents
