Sharp IM-DR580H(S) Service Manual page 23

Continuous Record
Enter the EEPROM setting mode, and press the SKIP UP button.
Change the MSL setting value from 00 to 08 by using CTRL_ (control setting menu).
(If the MSL remains in 00, no signal is recorded.)
• Continuous record from the current pickup position
T R E C
PLAY
AUTO1 Practice finish ?
YES
AUTO2 Practice finish ?
YES
A P # # # #
• Continuous record playback from any address
T R E C
DISP
A d 0 0 3 2
PLAY
A P # # # #
* When the [STOP] button is pressed in specific condition, the "TEST MODE STOP" state is set.
* In the start address set state the start address changes as follows when the [MENU] button is pressed.
0 0 3 2 (initial value)
H
A d 0 0 3 2
* In the start address setting state the start address change digit changes when the [REC] button is pressed.
1st digit (initial value)
A d 0 0 5 0
* In the start address set state the value of selection digit changes in the range of 0h to Fh when
the [SKIP UP/DOWN] button is pressed.
* In the continuous record state and start address set state the record laser power changes in the
range of "0h to Fh" when the [VOLUME +/-] button is pressed. (Initial value 0DH)
NO
E r A D J
NO
AUTO2 Practice
YES
No error ?
NO
A D J. N G
: Continuous record menu
: Start address setting
: Continuous record
# # # #: Address
0 3 C 0
H
A d 0 3 C 0 A d 0 7 0 0
0 9 5 0
H
A d 0 9 5 0
2nd digit
REC
A d 0 0 5 0
– 23 –
: Continuous record menu
: Continuous record
# # # #: Address
0 7 0 0 0 8 A 0
H
A d 0 8 A 0
3rd digit
REC
A d 0 0 5 0
REC
IM-DR580H
H