Introduction
WARNING:
safety chapter before you use the product.
To operate the product
1. Put the product around a support structure, such as
a branch.
WARNING:
at the intervals given below. There is a risk
of serious injury or death if defects are not
identified.
Note:
Refer to national regulations for other product
inspection intervals.
Product inspections must always be done before and
after each use. The operator can do these inspections.
If the product is used for equipment in occupational
health and safety according to EN 365, a product
inspection must be done at least each 12 months. This
inspection must be done by a competent person or the
manufacturer. The detailed instructions must be obeyed
and the findings written on the inspection sheets. Refer
Product inspection record sheet on page 6 and
to
Written inspection record sheet on page 6 .
To do a product inspection before each
use
•
Do a visual inspection of the product.
1751 - 003 - 16.03.2022
Operation
Read and understand the
Product inspection
Do the product inspections
WARNING:
as a single strand. Always use the
product in double strand configuration.
2. After the operation, remove the product, clean it and
put it into storage. Refer to
page 6 and Transportation and storage on page
7 .
•
If defects are found or if you are not sure that
the product is safe to use, take the product out of
To take the product out of service
service. Refer to
on page 7 .
To do a product inspection after each
use
•
Examine the product for abrasion and cuts.
•
Make sure that the product label is clearly visible and
easy to read.
•
If defects are found or if you are not sure that
the product is safe to use, take the product out of
To take the product out of service
service. Refer to
on page 7 .
To do a product inspection each 12
months
WARNING:
must only be done by a competent person
or the manufacturer.
The product inspection must be documented. Refer
Product inspection record sheet on page 6 and
to
Written inspection record sheet on page 6 .
Do not use the product
To clean the product on
This product inspection
5