AEG FSB42607Z User Manual page 14

14 www.aeg.com
8.3 How to activate
ExtraPower
1. Select a programme using MY TIME
selection bar.
2. Press
The light related to the button is on.
ExtraPower is not a
permanent option and must
be activated every time
before you start a
programme.
It is not possible to activate
or deactivate ExtraPower
while a programme is
running.
Activating ExtraPower
increases the water and
energy consumption as well
as the programme duration.
8.4 How to start the AUTO
Sense program
1. Press
The light related to the button is on.
2. Close the appliance door to start the
program.
The appliance senses the type of load
and adjusts a suitable wash cycle and its
duration.
8.5 How to delay the start of a
programme
You can delay the start of the selected
programme by 3 hours.
1. Select a programme.
2. Press
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible
to change the programme selection.
When the countdown is complete, the
programme starts.
.
.
.
8.6 How to cancel the delay
start while the countdown
operates
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
If you cancel the delay start,
you have to select the
programme again.
8.7 How to cancel a running
programme
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
Make sure that there is
detergent in the detergent
dispenser before you start a
new programme.
8.8 Opening the door while
the appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
8.9 The Auto Off function
This function saves energy by switching
the appliance off when it is not operating.
The function comes into operation
automatically:
• When the programme is completed.
• After 5 minutes if a programme was
not started.