NZ AU
of a problem please check all shown possibilities and follow below instructions before you
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service
10.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code
Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes.
AUTO
Automatic load detection is working; only in some programmes.
End
Lock
Door is closed because of high water level, high water temperature or spinning cycle.
bEEP OFF
The sound is deactivated.
bEEP ON
The sound is activated.
cLok
The keylock is activated. Deactivate to make changes to the selection.
The machine is in configuration for remote mode.
App
Add
The garment function is working.
dEF
Restore the default parameters for all programmes.
10.2 Troubleshooting with display code
Problem
Cause
CLr
・
Drainage error, water is not fully drained
within 6 minutes.
FLtr
E2
・
Lock error.
E4
・
Water level not reached after 12 minutes.
・
Drain hose is self-syphoning.
E8
・
Water protective level error.
10-Troubleshooting
Solution
・
・
Check drain hose installation.
・
Shut the door properly.
・
Make sure that tap is fully opened and water
pressure is normal.
・
Check drain hose installation.
・
Contact the After sales service.
23