Making A Phone Call - Jeep COMMANDER 2010 User Manual

ELECTRONICS
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth instructions in your cell phone user guide to complete the phone
pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and beep.
• (After the BEEP), say "uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP) say, "pair a phone".
• Follow the audible prompts.
• You will be asked to create a four-digit PIN which you will later need to enter into your
phone (typically..settings, bluetooth, device, list, new).
• You will then be prompted to give the phone pairing a name (each phone paired should
have a unique name).
• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven phones
may be paired).

Making A Phone Call

• Press the Phone button
• (After the BEEP), say "dial" (or "call" to a name).
• (After the BEEP), say number (or name).
Phonebook (uconnect™ local) Edit
• Press the Phone button
• (After the BEEP), say "phonebook".
• (After the BEEP), say "new entry" or "list names" or "delete".
• Follow the prompts.
Receiving A Call – Accept (And End)
• When an incoming call rings / is announced on uconnect™, press the Phone button
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice button
• (After the BEEP), say "mute on" (or "mute off ").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice button
• (After the BEEP), say "transfer call".
to begin.
.
.
.
.
.
36
.