Delivery, Transport, Storage; Delivery; Transport - AL-KO AT4F ATEX Series Operating And Assembly Instruction Manual

4

Delivery, transport, storage

4.1

Delivery

The unit dimensions are given in mm. Measurements such as AT4F 12x12 or AT4F 16x12 etc. are grid dimensions.
„
1 grid = 76.5 mm
The breakdown of the scope of supply is shown in the unit drawing.
„
Depending on their size, the AT4F ATEX Series central ventilation and air handling units are delivered either partially
„
disassembled, fully disassembled or fully assembled or as components bolted to square transport timbers accord-
ing to the breakdown of the scope of supply.
With the disassembled, partially disassembled or disassemblable AT4F ATEX unit version, an AL-KO straightener is
„
required.
4.2

Transport

26
Risk of explosion due to electrostatic discharge.
Unpacking (foil) can produce electrostatic charges, causing ignitable sparks. This can lead to
an explosion.
Unpack the unit during ATEX zone clearance.
„
Danger of death - Suspended loads.
For crane transport, all valid safety conditions according to DGUV regulation 52 Cranes and
DGUV Control unit 100-500 chapter 2.8 must be observed.
Do not walk under suspended loads.
„
Use the specified attachment and mounting points.
„
Observe the weight specifications.
„
Only use suitable lifting equipment.
„
Ensure that work on/in the AT4F ATEX unit takes place during ATEX zone freedom.
„
Risk of injury due to the module tilting or tipping over.
Failure to observe the safety instructions, standards, directives and regulations leads to a risk
of injury due to the AT4F ATEX unit tipping over.
Observe the applicable standards, directives and regulations.
„
Observe the instructions in these operating and assembly instructions.
„
Use the specified attachment and mounting points.
„
Observe the weight specifications.
„
Only work on on-site surfaces that are suitable for installation preparations and lifting.
„
Ensure that work on/in the AT4F ATEX unit takes place during ATEX zone freedom.
„
Any paint damage that occurs during transport can be rectified with a touch-up pen.
A touch-up pen can be ordered from AL-KO THERM if necessary.
WARNING
WARNING
CAUTION
NOTE
Translation of original operating instructions
AL-KO AT4F ATEX