Henden H3 Quick Start Manual

H3 Robotic Pool Cleaner
QUICK START
GUIDE
Thank you for purchasing the Henden H3 Robotic Pool Cleaner.
The Henden H3 uses clever cleaning and navigation technology to keep your pool
sparkling all year long. Designed for easy use and maintenance, the Henden H3 is
a quality piece of pool equipment guaranteed to last.

HELPFUL HINTS

• When working, the power supply should be placed
in the shade.
• Release minimal required floating cable length to
ensure proper pool coverage.
• Leave excess cable rolled outside the pool.
• After each cleaning cycle wash the filter bag or
cartridge. Clogged filter bags reduce scanning and
cleaning efficiency.
• To remove kinks stretch the cable out completely
and let it sit for at least a day in the sun.
• Once a week unplug the cable from the power supply,
unwind the tangled portions of the cable, straighten it
out and leave it in the sun for several hours.
• When not in use, store the pool cleaner in a shady
place upside down.
CAUTIONS AND WARNINGS:
Use the originally supplied power
supply only.
Do not use an extension cable in any
case whatsoever.
Ensure the electrical outlet is protected
by a ground fault interrupter (GFI) or an
earth leakage interrupter.
www.hendenpools.com.au/productregistration

SPECIFICATIONS

• Use the Robotic Pool Cleaner in the following
water conditions only: Chlorine Max 4 ppm;
pH 7.0-7.8; Temperature 6-34°C (43-93°F);
NaCl Maximum = 5000 ppm.
• Digital Power Supply: Input: 220-240 AC Volts;
50-60 Hertz; 120 Watt; Output: <30 VDC; IP 54.
• Motor protection: IP 68
Minimum depth: 0.80m/2.6ft
Maximum depth: 5m/16.4ft
Keep the power supply out of standing water.
Do not enter the pool while the Robotic Pool Cleaner
is working.
Unplug the power supply before servicing.
Do not pull the Robotic Pool Cleaner from the pool
using the cable.
Register your product online:
IMPORTANT
Please read carefully