Cobalt Aquatics C-VUE 18 Assembly Instructions Manual page 11

Step 7-Installing middle support
beam.
[requires four (4) 1/2" screws and two
(2) angle brackets
• Place beam inside stand on front edge
and behind top front panel.
• Line up angle bracket with pilot holes
• Secure with 1/2" screws.
• Be sure to make screws with tight
snug fit, but do not over tighten.
Step 6- Insert Shelf into stand
[requires four (4) shelf holders]
• Insert four (4) shelf holders into
pre-drilled holes.
• Press in firmly, you may need to
tap lightly with hammer.
• Place shelf onto shelf holders
11