Installation; Mounting The Bar Speaker Onto A Wall - iLive IT209B User Manual

█ MOUNTING THE BAR SPEAKER ONTO A WALL
• We recommend having this bar speaker professionally mounted.
By using the included wall mounting accessories, the bar speaker can be mounted onto a wall.
The included spacers should be used at your discretion to extend the face of the bar speaker farther from the
wall. These are typically used when mounting the bar speaker under a television, and the face of the bar speaker
needs to be flush with the face of the television.
Required Tools
• Manual or Power Screwdriver
• Stud Finder
• Pencil
• Tape Measure
• Level
Getting Started
1. Use the Tape Measure to decide how high you'd like
to hang the bar speaker on the wall.
The bar speaker must be hung within 6 feet of an
AC power outlet for the attached AC Power Cord to
reach.
2. Use the Stud Finder to locate 2 parallel wooden studs
to screw the mounting brackets into.
3. Mark the wall at the center of the studs using the
pencil.
4. Line the level up on both of your marks to make
sure they are level. If they're not, adjust the marks as
needed to make them level.
5. After you've double checked your markings, drill
through the top hole on both mounting brackets
directly into the marks you've made on the wall.
If you are using the brackets only and no spacers,
use the included short screws. If you are using any
of the spacers or combination of the spacers, use the
long screws.
6. Use the Level to level each of the hanging brackets,
then drill the second screw into the bottom hole on
both mounting brackets.
7. Slide the bar speaker onto the mounting brackets,
and make sure there is a firm and stable connection
before letting go of the bar speaker.
8. Finally, use the Level to confirm that the bar speaker
is level.
studs
screws
mounting
bracket
16"
IT209

INSTALLATION

spacer
IT209
9