Table of Contents
Advertisement
Specifications
Specifications and Limitations
This dispenser is designed to dispense cubed ice only and to be installed and operated indoors, in a
controlled enviroment. Its minimum and maximum operating temperature limits are the same as those for
the ice machine.
Limitations:
l Must meet the same limitations as the cuber installed on top of it.
l Must allow adaquate space for air flow when using and air cooled machine.
l Must allow space for utility connection at the back.
l Must have a drain.
l The CD300 is compatable with Ice-O-Matics cuber models ICE250, ICE400, ICE500 and ICE600.
l A thermostatic bin control kit is required on all ICE Series cubers. (Part Number 1051020-02)
Operating Requirements:
Air Temperature
Voltage
The CD300 dispenser has a 2 year Parts warranty and a 2 year Labor Warranty.
Model
Electrical
CD300P
115/60/1
CD300C
115/60/1
CD300K
115/60/1
Minimum
50° F
104 VAC
Amps
Vend Type
2.2
Push Button
2.2
Coin (25¢ Only)
2.2
Key Card
Page 2
Maximum
100° F
126 VAC
Check the nameplate, located on the back of the
dispenser cabinet for specific information.
Ice-O-Matic ice machines are not designed for
outdoor installations.
Machine requires voltage indicated on rating
nameplate. Failures caused by improper voltage are
not considered factory defects. Extended periods of
operation at temperatures exceeding limitations
constitutes misuse under the terms of the Ice-O-Matic
Manufacture's Limited Warranty, resulting in a loss of
warranty coverage. Specifications and design are
subject to change without notice.
Ice-O-Matic assumes no liability of any kind for
products manufactured by Ice-O-Matic that have been
altered in any way, including the use of any parts
and/or other components not specifically approved by
Ice-O-Matic.
Finish
Stainless Steel
Stainless Steel
Stainless Steel
CD300
Hide quick links:
Advertisement
Table of Contents
