Adjustments - Ice-O-Matic Hotel Dispenser CD300 Service & Installation Manual

Adjustments

The gear motor cam must be properly adjusted to properly position the dispensing rotor.
1. Disconnect electrical power to the dispenser.
2. Locate the sink key, unlock sink and remove it from the
dispenser.
3. Observe the position of the rotor through the cube chute.
The rotor and cam switch must be in the positions shown.
If they are not, the position of the cam must be adjusted.
4. Rotate the rotor until it has blocked the opening.
5. Loosen the cam on the shaft and rotate it until the cam
switch follower drops into the lowest part of the cam.
6. Tighten the cam onto the shaft.
7. Return the sink to its original position.
Proper position of rotor at rest.
Cube chute
opening.
Correct positions of cam and rotor at rest.
Page 12
CD300
Microswitch
cam follower.