Bosch PLR 50 C Original Instructions Manual page 20

20 | English
Digital laser measure
Automatic switch-off after approx.
– Laser
– Measuring tool (without measurement)
– Bluetooth® (when inactive)
Batteries
Data transmission
Bluetooth®
Operating frequency range
Max. transmission power
A) When measuring from front edge. In unfavourable conditions such as very strong lighting, a tem-
perature greatly deviating from 25 °C or a poorly reflecting surface, the measuring range can be
restricted.
B) In unfavourable conditions such as strong lighting, high altitudes or a poorly reflecting surface, the
maximum deviation can be ±4 mm with a deviation of ±0.15 mm/m. In favourable conditions, a
deviation of ±0.05 mm/m needs to be taken into account.
C) In continuous measurement mode, the max. operating temperature is +40 °C.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by con-
densation is expected.
E) Bluetooth® deactivated
F) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® tools must support the GATT profile.
The serial number (6) on the type plate is used to clearly identify your measuring tool.
Inserting/Changing the Battery
Always replace all the non-rechargeable batteries at the same time. Only use non-
rechargeable batteries from the same manufacturer and which have the same ca-
pacity.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
Take the non-rechargeable batteries out of the measuring tool if you are not using
u
it for a long time. The non-rechargeable batteries can corrode and self-discharge dur-
ing prolonged storage.
1 609 92A 6KZ | (20.08.2021)
E)
PLR 50 C
20 s
5 min
3 min
3 × 1.5 V LR03 (AAA)
Bluetooth® 4.2
F)
(Low Energy)
2402–2480 MHz
2.5 mW
Bosch Power Tools